-Connection unit for mounting on a TH35 mounting rail in accordance with DIN EN 60715 in electrical distributors for domestic and industrial installations -equipped with a C6A module 270° RJ45 single module -Cable access 45° from below, plug direction inclined 45° downwards -GHMT Cat.6A re-embedded PVP certified -Cat.6A component testing in accordance with ISO/IEC 11801 Ed.2.2:2011-06, DIN EN 50173-1:2011-09, TIA/EIA-568-C.2 (2009-08) and IEC 60603-7-51 Ed.1 (12/2008), GHMT certified -Compliance with class EA up to 500 MHz in accordance with ISO/IEC 11801 Ed.2.2:2011-06, DIN EN 50173-1:2011-09 -tested: component up to 600 MHz, link up to 800 MHz -suitable for 10GBit Ethernet (IEEE 802.3an), remote powering (PoE, PoE plus, UPoE and 4PPoE) and HDBaseT -easy to install connection of data cables AWG 26/1 - 22/1 (single-wire) and AWG 26/7 to 22/7 (multi-wire) to IDC insulation displacement terminals -marking of the wire assignment T568A and T568B directly on the charging piece -the width of 1TE enables the installation of up to 12 REGplus in standard electrical distributors -when installed as a device of protection class I, the potential equalization takes place via an integrated potential equalization plate directly above the mounting rail, which is to be connected to the building potential equalization via corresponding contact terminals -the module is protected against direct contact by a cover. When installed in protectively insulated distributors, protection class II is maintained. The potential equalization spring must be removed for this. -integrated dust protection flap (also available in color)